First picture of my TT. This was the ad I saw on the dealership website.

For this I used:

GPS Unit
GadgeTT from www.modshack.info
Extra 12V socket from Autozone

Done at 64,000 Miles
I sourced the parts Here:
http://www.dieselgeek.com/
I used this write-up:
http://www.amp82.co.uk/tt/timingbelt/
I added these comments:
http://forums.audiworld.com/tt/msgs/1525694.phtml

Installed at 69k miles

European Aluminum Binder - Perfect Touch for the Euro Dash.

Porsche Convertible Top Cleaner
PN 99990101441

Porsche Convertible Top Conditioner
PN 00004400075

Done at 69,795 miles

Never Installed - Saving it for trips to GTG's

This mod allows your turn signal to flash either 3,4,5 times when the stalk it lightly touched. This feature is on lots of newer cars sometimes referred to as a courtesy flash – normally used when changing lanes in traffic.

If your interest in one e-mail Mike at MCPaudiTT@bigfoot.com for more information. The full kit with shipping to the Continental US is $100 (e-mail me if you are interested, but not in the US or in Alaska or Hawaii). (*I'm not selling them, but Mike's a great guy to deal with*)

You can see them in action here (right-click and use "Save As..."):

Hi-Res (24 MB):

www.Straightfocus.com/TT/MCPaudiTT/Short_Burst_Blinker_Hi-Res.MOV

Lo-Res (3 MB):

www.Straightfocus.com/TT/MCPaudiTT/Short_Burst_Blinker_Lo-Res.MOV

Strut Cap Polishing 'How To' pictured. Purchased these from Forge for $30 when they were cleaning out there unpopular colors. Just took a little sanding and the red anodizing came right off. Add a little polish and they match the other polished Forge caps nicely.

Porsche 928GTS 4 pot Calipers
*PN 928 351 423 03*
*PN 928 351 424 03*
3.2TT / R32 Rotors
I ordered mine from www.parts4vw.com when they were on sale.
Stainless Steel Lines
*ECS for rear and MCPaudiTT part swap for fronts*
Custom Mounting Brackets
*Milled from 7075-T651 Aluminum*
Speed Bleeders
*eBay*

Basic Tools Needed:
Jack and Stands –or- Two Jacks – Ramps work great too.
Big Flat Screw Driver
Socket Wrench (3/8” or ½”)
17mm socket
13mm socket
Extension Bar
WD-40
13mm wrench (Needed to get one bolt if you removing the center bracket)

If anyone is interested in one of these in silver or black shoot me an email: wilsow2@alum.rpi.edu Also, if you have any questions or would like to mount something else to it I can work with you to make a custom setup.